So I power the base station on, the power light turns on. The motors start and a pair of red lights blink on the inside. Then the power light blinks a handful of times and everything then proceeds to turn off. Base station is mounted atop my monitor with velcro tape. It is level.
Rinse and repeat. Plugged or unplugged. Problem persists after letting it charge overnight.
This is the most recent issue. I actually had it working - sort of, before I left it with an overnight charge. Other issues include when loading SteamVR home - I'm in the floor. Oh, I was in the ceiling once too. Not sure if that's Nolo or Trinus or if I just did calibration entirely wrong but boy is that disorienting. Need to tinker further.
Oh. And the controllers don't like to stay on. At all. If I set them down for even an exceedingly short period of time, they turn off. And then they don't seem to exist unless I go through pairing again - which I can't do anymore 'cause the base station won't turn on!
I'm not half bad with computers. I tried to do my research - there's very little existing documentation for troubleshooting that I've found. I wasn't anticipating this to be such a struggle, the entire point of this purchase was to make things EASIER. I've been trying to get this working off and on for a week now.
So if anyone has any idea about any of this, I'd sincerely appreciate your input.
-One frustrated lady trying to get her PSVR trying to work with Trinus and Nolo.